Dongguan International Technology Transfer Center, 124 Dongbao Road, Dongcheng District, Dongguan, China
Request a quote
Cartridge Heaters — High Watt Density
Cartridge Heaters - High Watt Density

Cartridge Heaters — High Watt Density

High watt density cartridge heaters up to 25 W/cm2 with 316L or Incoloy sheath options, for hot runner nozzles, fast-cycle molds and tight spaces.

Sourced to the machine you actually run

Give us the machine model, tonnage or the space it has to fit. We confirm the exact unit, controls and options before quoting.

Quoted to confirmed specs

Engineering review Monday to Saturday. Send the machine model and the output you need — the reply carries price, scope and delivery.

Email engineering

Not sure which size fits? Send the machine model or a photo of the existing unit and we will match it.

Details

Specification & application

When the hole is small but the heat demand is large, watt density has to go up. These cartridges are wound with a finer resistance wire and a denser magnesium oxide fill, so the same 10 mm diameter that carries 200 W in a standard element can carry 600 W.

Specifications

ParameterRange
Diameter3 - 20 mm, including 6.5 and 8 mm hot runner sizes
Watt density15 - 25 W/cm²
Sheath304 SS, 316L SS, Incoloy 800 for corrosive service
Maximum sheath temperature800 °C (short cycle)
ToleranceDiameter -0.02 / -0.05 mm on request
SensorIntegrated type J or K, tip sensitive

Where high watt density earns its price

  • Hot runner nozzle tips, where space is measured in millimeters
  • Fast-cycle molds needing rapid recovery after ejection
  • Manifold drops that lose heat to a cold mold
  • Medical and packaging tooling with short cycle targets

The trade-off, stated plainly

High watt density shortens element life if the fit or the control is poor. The sheath runs hotter, so scale, resin drool or a loose hole will burn it out quickly. Use a controller with fast sampling and a properly placed thermocouple, keep the cold zone outside the heated block, and expect to replace these more often than a standard cartridge in the same application. That is the honest cost of packing the power in.

If the bore allows it, a standard watt density cartridge will outlast it. If the application is a hot runner, see also hot runner control systems.

Related

Other components in this range

View category

Need this part matched to your press?

Send the machine model and the resin. We confirm geometry, material and surface treatment before quoting.

Cartridge Heaters — High Watt Density Quoted to confirmed specs