Dongguan International Technology Transfer Center, 124 Dongbao Road, Dongcheng District, Dongguan, China
Request a quote
Cartridge Heaters — Standard Watt Density
Cartridge Heaters - Standard Watt Density

Cartridge Heaters — Standard Watt Density

Standard watt density cartridge heaters, 6-25 mm diameter, 304 stainless sheath, up to 750 C, for molds, platens, packaging equipment and general heating.

Sourced to the machine you actually run

Give us the machine model, tonnage or the space it has to fit. We confirm the exact unit, controls and options before quoting.

Quoted to confirmed specs

Engineering review Monday to Saturday. Send the machine model and the output you need — the reply carries price, scope and delivery.

Email engineering

Not sure which size fits? Send the machine model or a photo of the existing unit and we will match it.

Details

Specification & application

Standard watt density cartridge heaters are the general-purpose building block of industrial heating: a cylindrical element pressed into a drilled hole, sized so the sheath surface load stays moderate and the element lives a long time.

Specifications

ParameterRange
Diameter6, 8, 10, 12, 16, 20, 25 mm (metric and inch)
Length25 - 500 mm, tolerance ±1.5 mm
Watt densityup to 15 W/cm²
Maximum sheath temperature750 °C
Sheath304 stainless steel
InsulationHigh purity magnesium oxide
TerminationStranded lead wire, ceramic beads, terminal pin, threaded fitting
OptionsBuilt-in thermocouple, braided lead, flange, taper fit

Typical applications

  • Injection mold hot sprue bushings and cavity inserts
  • Platens and hot plates
  • Packaging seal bars and shrink tunnels
  • Laboratory and analytical equipment
  • Water and oil immersion, where a sealed fitting is used

Fit matters more than wattage

A cartridge heater transfers heat by contact. Drill the hole 0.1 - 0.2 mm over nominal, ream it, and clean out the chips; a loose fit in a rough hole will overheat the element regardless of how conservative the watt density is. Never hammer a cartridge into place, and always leave the cold length clear of the heated zone or the lead end will cook.

For tighter spaces or faster response, the high watt density range packs more power into the same diameter.

Related

Other components in this range

View category

Need this part matched to your press?

Send the machine model and the resin. We confirm geometry, material and surface treatment before quoting.

Cartridge Heaters — Standard Watt Density Quoted to confirmed specs