Mica Barrel Heater Bands — Zone Setup
Mica barrel heater bands for injection and extrusion machines: 60-400 mm ID, 40-200 mm width, 500-3000 W per zone, with terminal boxes and thermocouple options.
View details
Mica barrel heater bands for injection and extrusion machines: 60-400 mm ID, 40-200 mm width, 500-3000 W per zone, with terminal boxes and thermocouple options.
Give us the machine model, tonnage or the space it has to fit. We confirm the exact unit, controls and options before quoting.
Engineering review Monday to Saturday. Send the machine model and the output you need — the reply carries price, scope and delivery.
Not sure which size fits? Send the machine model or a photo of the existing unit and we will match it.
Barrel heater bands wrap the feed, compression and metering zones of an injection or extrusion barrel. Compared with nozzle bands they are wider, higher powered, and usually supplied with a protective terminal box because they operate in the busiest part of the machine.
| Zone | Width | Power | Notes |
|---|---|---|---|
| Feed zone | 60 - 120 mm | 800 - 2000 W | Often water cooled underneath |
| Compression zone | 80 - 160 mm | 1200 - 3000 W | Highest heat demand |
| Metering zone | 60 - 120 mm | 800 - 2000 W | Paired with thermocouple |
| Nozzle | 25 - 60 mm | 150 - 600 W | See nozzle band heaters |
Almost every premature failure we see has one of three causes. Resin or purging compound has run down inside the band and carbonised, shorting the element. The band was clamped over a corroded or scaled barrel, so contact is poor and the element overheats locally. Or the lead wire was routed against a hot surface and the insulation hardened and cracked. All three are installation issues, not manufacturing defects, and all three are avoidable.
Pair these bands with barrel blankets to cut radiant loss, and check zone wiring against the hot runner control systems section if you run a manifold.
Mica barrel heater bands for injection and extrusion machines: 60-400 mm ID, 40-200 mm width, 500-3000 W per zone, with terminal boxes and thermocouple options.
View detailsSend the machine model and the resin. We confirm geometry, material and surface treatment before quoting.
Have a drawing? Reply to our confirmation email with the file attached — PDF, STEP, DXF or a photo of the part all work.
Our engineering team answers during working hours, Monday to Saturday. For urgent orders, call +8613751260808.