Mica Nozzle Band Heaters — Specifications
Mica nozzle band heaters for injection molding machines: 25-160 mm ID, 3-6 W/cm2, up to 480 C, 304 stainless sheath, optional J or K thermocouple.
View details
Mica nozzle band heaters for injection molding machines: 25-160 mm ID, 3-6 W/cm2, up to 480 C, 304 stainless sheath, optional J or K thermocouple.
Give us the machine model, tonnage or the space it has to fit. We confirm the exact unit, controls and options before quoting.
Engineering review Monday to Saturday. Send the machine model and the output you need — the reply carries price, scope and delivery.
Not sure which size fits? Send the machine model or a photo of the existing unit and we will match it.
Mica nozzle band heaters clamp around the injection nozzle to hold melt temperature between the barrel and the mold. The mica core insulates a nickel-chromium resistance ribbon, and the stainless steel sheath protects it from resin drool, purging compound and repeated clamp-on cycles. This is the workhorse heater for general-purpose resins where the nozzle runs below roughly 400 C.
| Parameter | Typical range |
|---|---|
| Inside diameter | 25 mm - 160 mm (custom to 400 mm) |
| Band width | 25 mm - 80 mm |
| Voltage | 220 V / 380 V, single or three phase |
| Watt density | 3 - 6 W/cm² |
| Maximum sheath temperature | 480 °C (900 °F) |
| Sheath material | 304 stainless steel, optional 321 |
| Insulation | Mica board and mica paper |
| Lead wire | 300 - 1000 mm, fiberglass or ceramic bead |
| Sensor (optional) | Type J or K thermocouple, grounded or ungrounded |
Three dimensions decide fit: the nozzle outside diameter, the band width that clears the mold sprue bushing, and the terminal position. Measure the nozzle OD with a caliper rather than guessing from the machine tonnage. Wattage then follows the heated area — roughly 4 W/cm² is a safe starting point for a nozzle that must recover quickly after each shot, and 3 W/cm² is enough for slow-cycle commodity resins.
If the barrel runs above 400 °C, or the resin is glass-filled, step up to a ceramic heater band instead. Ceramic insulation tolerates higher surface temperatures and does not absorb moisture the way mica can.
Send us the nozzle OD, width, voltage and wattage and we will confirm the drawing before production. Non-standard diameters and cut-to-width bands are normal work for us, not exceptions.
Mica nozzle band heaters for injection molding machines: 25-160 mm ID, 3-6 W/cm2, up to 480 C, 304 stainless sheath, optional J or K thermocouple.
View detailsSend the machine model and the resin. We confirm geometry, material and surface treatment before quoting.
Have a drawing? Reply to our confirmation email with the file attached — PDF, STEP, DXF or a photo of the part all work.
Our engineering team answers during working hours, Monday to Saturday. For urgent orders, call +8613751260808.