Custom Screws by Machine Model: The Dimension Chain We Confirm

"Can you make a screw for my machine if I only have the model?" Yes - but the model alone is not enough. A screw that bolts on and plasticizes correctly needs a full chain of dimensions confirmed before steel is cut. This is what we ask for, in order.
Ring 1: diameter and L/D
Same machine model, different screw diameters - re-gauging is a common retrofit, so the diameter must be measured, not looked up. Flight outside diameter on the old screw, or bore diameter on the barrel, measured in several positions. Total length from the drive end to the flight top gives the L/D together with the diameter. Keep the melt-recovery stroke in mind: some machines limit usable screw length.
Ring 2: shank and drive connection
The connection to the drive is where one-off screws most often go wrong: thread or keyway specification, piston rod coupling (threaded, splined, flanged or shouldered), and the tip thread that carries the screw head assembly. If no drawing exists, clear photos of these features with a scale or caliper in frame let us reverse most of them. When doubt remains, sending the old screw for measurement is the safe route.
Ring 3: feed section and throat
The feed flight must line up with the barrel's feed opening or material delivery turns erratic: symmetric or offset throat, opening length and position, grooved-feed liners on forced-feeding machines, and water-cooled feed sections all change the feed-zone geometry that must be matched.
Ring 4: geometry by resin
The first three rings make the screw fit; this one makes it work. We need the resin and filler loading, the process problem if any (low output, slow recovery, color streaks), and the measured bore diameter so the new flight clearance is matched to the real bore rather than the nominal one. With those inputs we propose the profile - general purpose, barrier or mixing - and send the full dimension list for written confirmation before machining.
How we handle the unknowns
| Unknown | How we resolve it |
|---|---|
| Model known, no drawing | Machine-standard parameters + photos / old part cross-check |
| Re-gauged or unknown history | Measured bore and old screw required |
| Uncertain shank connection | Old part sent in, or photos for a first check |
| Original compression ratio unknown | Measured from old screw channel depths |
| Resin unclear | Conservative profile with stated adjustment room |
The cost of this process is one extra round of communication. The benefit is a screw that runs on first installation - quotation follows written confirmation of the full dimension chain, never "close enough".
相关产品
Only have the machine model? Send it with photos of the old screw and the resin you run - we will reply with a dimension confirmation list.