Dongguan International Technology Transfer Center, 124 Dongbao Road, Dongcheng District, Dongguan, China
Request a quote
Injection Molding Barrels — Nitrided, Bimetallic
Barrels for Injection Molding

Injection Molding Barrels — Nitrided, Bimetallic

Barrels for injection and extrusion machines with nitrided or bimetallic liners, machined to your screw dimensions and inspected against drawing.

Made to your drawing, sample or part number

Machined to your barrel dimensions and screw geometry — no catalogue constraints. Single replacement part or production batch.

Quoted to confirmed specs

Engineering review Monday to Saturday. Send the machine model, screw diameter and resin — the reply carries price, material grade and lead time.

Email engineering

No drawing on file? Send a photo of the worn part and the machine model — we work the geometry back and confirm it with you before machining.

Details

Specification & application

Barrels wear from the inside, and the failure is quiet. A bore opens up by a few hundredths of a millimeter, the screw-to-barrel clearance grows, and the symptom is not a leak — it is a longer recovery time and a melt that will not hold pressure.

We machine barrels to your screw, or as a matched pair. The bore, the feed opening and the flange are cut to the machine interface you are bolting to.

Construction

TypeHow it is builtWhere it fits
Solid nitridedOne piece 38CrMoAlA, nitrided through the boreGeneral purpose, unfilled resins; the economical choice
Bimetallic linedSteel shell with a centrifugally cast alloy linerGlass and mineral filled compounds, abrasive fillers
VentedTwo zones with a vent port and a decompression sectionMoisture-bearing and regrind-heavy feeds
Grooved feedGrooved throat section with a matched screwHigher output on HDPE and PP, stable solids conveying

What decides life

  • Filler hardness rather than filler percentage — a small loading of a hard mineral can do more damage than a heavy loading of a soft one.
  • Screw alignment. A barrel that is out of line with the drive wears on one side first.
  • Barrel heaters running hot because a thermocouple has drifted. Over-temperature softens the nitrided layer and it goes quickly after that.
  • Purging practice. Left-over resin that carbonises in the bore becomes the abrasive.

Matching to the screw

A barrel is only half the pair. We set the bore-to-flight clearance against the screw we are supplying, and when you send an existing screw we measure the flights before cutting the bore. If only the barrel is being replaced, give us the screw diameter and the wear you have measured.

What we need to quote

  • Machine make and model, or bore diameter, barrel length and flange drawing.
  • Whether the screw is being replaced at the same time.
  • Feed opening position and throat style.
  • Heater band layout, if the barrel is supplied drilled and tapped for it.

Bore tolerance, liner thickness and hardness are confirmed on the drawing for each order. The construction options above describe what we can make, not a stock specification sheet.

Related

Other components in this range

View category

Need this part matched to your press?

Send the machine model and the resin. We confirm geometry, material and surface treatment before quoting.

Injection Molding Barrels — Nitrided, Bimetallic Quoted to confirmed specs