Injection Molding Barrels — Nitrided, Bimetallic
Barrels for injection and extrusion machines with nitrided or bimetallic liners, machined to your screw dimensions and inspected against drawing.
View details
Hardened bore for commodity and engineering resins without aggressive fillers.
Machined to your barrel dimensions and screw geometry — no catalogue constraints. Single replacement part or production batch.
Engineering review Monday to Saturday. Send the machine model, screw diameter and resin — the reply carries price, material grade and lead time.
No drawing on file? Send a photo of the worn part and the machine model — we work the geometry back and confirm it with you before machining.
A nitrided barrel is the standard economical construction: a 38CrMoAlA tube, bored and honed, then gas nitrided so the bore carries a hard case over a tough core. The case resists abrasion; the core keeps the barrel from cracking under hoop stress.
| Parameter | Typical range | Confirmed at order |
|---|---|---|
| Base material | 38CrMoAlA (JIS SACM645) or equivalent | Mill certificate supplied on request |
| Case depth | Commonly 0.3 to 0.6 mm on the bore | Measured on a test coupon from the same batch |
| Surface hardness | Commonly HRC 56 to 58 band | Verified after nitriding |
| Bore finish | Honed, typically Ra 0.4 µm or better | Checked with a profilometer before dispatch |
| Straightness | Controlled along the full length | Dial-checked on the bench |
| Bore tolerance | Set against the screw clearance | Agreed on the drawing |
Most nitrided barrels we replace were not worn out by the resin. They were worn out by heat: a drifting thermocouple that ran the zone hot softened the case, and after that the wear is rapid. Check the heater bands and thermocouples before blaming the barrel.
Barrels for injection and extrusion machines with nitrided or bimetallic liners, machined to your screw dimensions and inspected against drawing.
View details
Wear-resistant liner for glass-filled, mineral-filled and abrasive compounds.
View details
Vent port and decompression zone for hygroscopic and recycled material.
View detailsSend the machine model and the resin. We confirm geometry, material and surface treatment before quoting.
Have a drawing? Reply to our confirmation email with the file attached — PDF, STEP, DXF or a photo of the part all work.
Our engineering team answers during working hours, Monday to Saturday. For urgent orders, call +8613751260808.