Dongguan International Technology Transfer Center, 124 Dongbao Road, Dongcheng District, Dongguan, China
Request a quote
Nozzle Bodies, Adapters and Tips
Nozzle Bodies and Tips

Nozzle Bodies, Adapters and Tips

Nozzle bodies, replaceable tips, adapters and mold clamps in standard and special sizes, matched to your machine and mold.

Made to your drawing, sample or part number

Machined to your barrel dimensions and screw geometry — no catalogue constraints. Single replacement part or production batch.

Quoted to confirmed specs

Engineering review Monday to Saturday. Send the machine model, screw diameter and resin — the reply carries price, material grade and lead time.

Email engineering

No drawing on file? Send a photo of the worn part and the machine model — we work the geometry back and confirm it with you before machining.

Details

Specification & application

The nozzle is the last place the melt is controlled before it enters the mold, and the first place a cold slug forms. Orifice size, land length and the way the tip seals against the sprue bushing decide whether you get a clean break or a string.

We supply bodies, tips and extensions to match the machine and the tool, in the thread and seat form your barrel end uses.

What we make

PartFunctionSelection notes
Nozzle bodyCarries the melt from the barrel to the tip, often heatedLength set by the gap between barrel end and mold; heater and thermocouple position matter
Open tipStraight through orifice, no mechanical shut-offCommodity resins, free-flowing melts; simplest and least to go wrong
Shut-off tipSpring or needle closes the orifice between shotsLow viscosity resins and engineering grades where drool is unacceptable
ExtensionAdds length between body and tipDeep molds, or when the barrel cannot reach the sprue bushing

Sizing the orifice

A larger orifice fills faster and shears the melt less. A smaller one gives a cleaner break but raises pressure and can freeze off on a fast cycle. For filled resins, the orifice has to clear the filler — a glass-filled grade through an undersized tip will erode the seat and then leak.

Interfaces

  • Thread form and seat angle must match the barrel end; metric and imperial forms are not interchangeable even when the diameters look close.
  • Heater wattage and thermocouple type should be confirmed with the body, not after it arrives.
  • Where a hot runner is downstream, the tip radius has to match the sprue bush radius exactly, or you will get a ring of flash at the gate.

What we need to quote

  • Barrel end drawing, or the existing nozzle for measurement.
  • Resin and filler content.
  • Required tip-to-sprue distance and the sprue bush radius.
  • Whether shut-off is needed, and if so the spring or needle style you prefer.

Orifice diameters and thread forms are set per order against your barrel end. Send the drawing or the worn part and we will match it rather than guess from a size code.

Related

Other components in this range

View category

Need this part matched to your press?

Send the machine model and the resin. We confirm geometry, material and surface treatment before quoting.

Nozzle Bodies, Adapters and Tips Quoted to confirmed specs