Troubleshooting Black Specks and Burn Marks
Trace black specks and burn marks to their real source: barrel residence time, hot runner dead spots, screw wear, or resin handling.
Read moreNotes on screw geometry, wear, resin behaviour and the practical side of keeping a press running.
Trace black specks and burn marks to their real source: barrel residence time, hot runner dead spots, screw wear, or resin handling.
Read more
How to map hot runner zones to drops, set soft start and standby temperatures, and avoid the start-up mistakes that carbonise resin.
Read more
A practical preventive maintenance schedule for screws, barrels, heaters, nozzles and non-return valves, by daily, monthly and annual interval.
Read more
How to measure the real energy saving from barrel insulation blankets before and after installation, including the numbers to expect.
Read more
A practical purging procedure for color and resin changes: temperature, quantity, dwell time and how to tell when the barrel is actually clean.
Read more
What compression ratio means in an injection screw, how it is calculated, and how to choose it for commodity, engineering and shear sensitive resins.
Read more
How screw tip and non-return valve design changes with resin: free-flow, ball check and sliding ring tips, and what each does to shot repeatability.
Read more
Mica and ceramic band heaters compared on temperature limit, watt density, moisture tolerance, life and price, with a selection rule for each.
Read more
The four causes of premature heater band failure, how to identify each from the failed part, and the installation habits that prevent them.
Read moreSend us a photo of the failed part and what you were running. We will tell you what usually causes it.